Contact Us | Sign In | Register
Call Now: (800) 333-8249

Ceiling Lift Track Components

X-Y Gantry Traversing Trolley Set

The X-Y Gantry Traversing Trolley Set is used to connect the traversing boom to the parallel support rails for an X-Y gantry system. It has charger connections to engage with the end stop charger.

X-Y Gantry Traversing Trolley Set

The X-Y Gantry Traversing Trolley Set is used to connect the traversing boom to the parallel support rails for an X-Y gantry system. When used with the P-400 and P-600, it does not include any charging connection hardware.

X-Y Gantry Manual Traverse Above Mount Trolley Set

X-Y Gantry Manual Traverse Above Mount Trolley Set is used where additional lifting height is required. The traversing rail travels at the same height as the support rails.

X-Y Gantry Power Traversing Trolley Set

The X-Y Gantry Power Traversing Trolley Set allows for full power operation of the X-Y gantry boom. The boom travel is activated via buttons on the hand control.

Charger End Stop

A Charger End Stop is used with lifts permanently installed in the track (C Series and TA Plus). It acts as both an end-stop and the charger docking station.

End Stops and End Stop Safety Pins

The Mid-Track Charger allows the lift to be charged at any location along the track.

End Stops and End Stop Safety Pins

The End Stops hold the lift or X-Y Gantry trolley set inside the track and are located at each end of the track. The End Stop Safety Pin is an additional safety measure.

Auto-Gate

The Auto-Gate enables a transfer between an X-Y Gantry and a single track. The Auto-Gate's revolutionary design does not require the use of any electrical components. Simply driving the lift into the gate locks it in place to transfer to the other rail.